Advantages of TATA Tiscon

100 percent pure steel Made from pure iron ore through the blast furnace route.
Higher Safety and Higher Durability.
Higher Seismic Resistant.
Higher Bond Strength With Cement and Higher Safety and Security.
Higher Longivity on High temperature and Extreme Cold condition
Quality Never Fails
Assurance for Quality, Trust and strength.

Advantage of using Tata Tiscon 500 D:

A superior and controlled steel making practice can reduce the levels of these impurities. The last revision (2008) in Bureau of Indian Standards (BIS),factors in this aspect & includes a new superior category of rebar called "D" This new category specifies steel with minimum of harmful impurities- S & P. Such low S&P levels, as specified in the 500-D specifications of BIS, are almost impossible to be achieved through normal scrap & induction furnace route. However, at Tata Steel, due to state of the art steel making facilities as well as the stringent quality controls at every step from mines to the mills, 100% of the rebars are now produced in compliance with the 500 D grade specifications We now offer you TATA TISCON 500-D where the combined level of Sulphur and Phosphorus is restricted to a maximum of 0.075% to comply with the latest BIS specifications. b. Sizes- 6, 8, 10, 12, 16, 20, 25, 28, 32,36 and 40 mm.

Advantage of using Tiscon CRS:

ADVANTAGES OF TATA TISCON CRS Longer life due to superior corrosion resistance High yield strength, coupled with good ductility and bendability No extra precaution required in material handling and transportation No maintenance during fabrication Ideally suited to poor working conditions at site No extra precaution during welding.

Advantage of using Tata Tiscon Super Ductile Rebar:

A superior and controlled steel making practice can reduce the levels of these impurities. The last revision (2008) in Bureau of Indian Standards (BIS),factors in this aspect & includes a new superior category of rebar called "D" This new category specifies steel with minimum of harmful impurities- S & P. Such low S&P levels, as specified in the 500-D specifications of BIS, are almost impossible to be achieved through normal scrap & induction furnace route. However, at Tata Steel, due to state of the art steel making facilities as well as the stringent quality controls at every step from mines to the mills, 100% of the rebars are now produced in compliance with the 500 D grade specifications We now offer you TATA TISCON 500-D where the combined level of Sulphur and Phosphorus is restricted to a maximum of 0.075% to comply with the latest BIS specifications. Sizes- 6, 8, 10, 12, 16, 20, 25, 28, 32 36 and 40 mm.

TATA Tiscon